Wand display
We made a lot of wands - we need a display to hold them
After we finished our third wand we had to realize we need something to hold and display them. Of course we used the 3D printer to create a display.
It was a relatively easy design, just two plates with four big holes to the four wands and four pillar to hold the two plates in place.
The print went without any problem and the result turned out better than we expected. After gluing it together we decided this looks good enough to not paint it. At least not yet. We are far behind with the painting jobs already, so it's good to have something which doesn't have to be painted.
The display looks pretty good with the wands too. There are two wands on the picture: the snake wand and Voldemort's wand.
It is very likely we will sell this as a kit as well, because it's easy to assemble and the result is more then good looking.